Mini-lab setup

kenknight · Post by **kenknight** » 11. Aug 2008, 19:57

Hi all,

I've read through the manual and I'm not sure I'm going to be able to accomplish this, so I figured I'd post a note to see if anyone else has accomplished this since forum searches didn't yield much.

I'm trying to setup a mini-lab. Essentially I want two or more VM's running on their own subnet, yet able to access the outside world AND see each other.

I tried "Internal Networking" and that appears to only allow inter-VM communication. When I tried NAT, both of the Vm's have the same internal IP of 10.0.2.15. Bridging puts them on my internal subnet.

Any suggestions would be greatly appreciated.

Thanks,
Ken

kenknight · Post by **kenknight** » 11. Aug 2008, 22:38

I think I have a solution. The first network adapter is set to internal... the second is set to NAT. This seems to be working, although, it wasn't until I install 1.6.4.

Thanks,
Ken