debian. Loading, please wait

[ILya1]

After full-upgrade on debian cant boot.

After installed, default for now:
vmlinuz-4.2.0-1-686-pae

But it write "Loading, please wait" when boot. Log "VBOX_two_network.txt" in attachment.

So if I disable all network card, or use just one in setting of virtualbox machine. Then all good boot... Log "VBOX_no_one_network.txt" in attachment.

[Perryg]

Code: Select all

00:00:01.585894 HM: HMR3Init: Falling back to raw-mode: VT-x is disabled in the BIOS for both all CPU modes

First if you take care of the above error your guest will perform better.

Next:
From the hosts terminal/command window type VBoxManage showvminfo <VM Name> --details and post here. Replace <VM Name> with the actual name of the VM. Use " " if the name has a space in it. While you have the two adapters enabled.

Note if the host is Windows you need to be in the directory that has VBoxManage.exe for the command to work.

[ILya1]

Thank you very much for so fast reply!

[ILya1]

Linux 3.12-1-686-pae booting good...

[Perryg]

NIC 1: disabled

NIC 2: MAC: 08002754B0FB, Attachment: Bridged Interface 'Realtek PCIe GBE Family Controller', Cable connected: off, Trace: off (file: none), Type: 82540EM, Reported speed: 0 Mbps, Boot priority: 0, Promisc Policy: deny, Bandwidth group: none

NIC 3: MAC: 080027FE4A44, Attachment: Bridged Interface 'Realtek RTL8139/810x Family Fast Ethernet NIC', Cable connected: off, Trace: off (file: none), Type: 82540EM, Reported speed: 0 Mbps, Boot priority: 0, Promisc Policy: deny, Bandwidth group: none

Your file shows that both of the adaptors have the virtual cable removed, meaning no traffic can be possible. If you change one to NAT instead of both being bridged, does it boot properly?

[ILya1]

Try, but same "Loading, please wait".

[Perryg]

Can you give me a reason for the two network adapters? Also it appears that it is the guest that is not playing well with the configuration. ( evidenced by an older kernel working ).

[ILya1]

One cable to lan, other to wan.

Need for students who need internet. Server-proxy.

[Perryg]

Very well, I was just curious. It still appears to be a guest issue to me. If you disable either one of the adapters the guest works properly or if you select an older kernel in the guest it boots properly, is this correct?

[ILya1]

Yes, correct.

Sorry for my english, btw...

[Perryg]

Your English is more than adequate.

At this point you need to investigate the issue at the guest level. All VirtualBox does is provide the interfaces and the guest is what decides what to do with it. You might ask the Debian folks if they have seen this problem with the kernel you are trying to use or the Linux kernel DEVs.

[ILya1]

All work! Cool!!

Thank you very much Perryg.

After you say enable VT-x, I enable it in bios for increase perform, and vmlinuz-4.2.0-1-686-pae booting without any problem. Strange...

Now I can configure linux, finally.

Thank you again!

[ILya1]

Topic may close...