Please Help... VirtualBox completely screwed up

[CountryLawyer]

I have searched here for help without success. I cannot log into my accounting or recording software, which I use in Windows XP Mode in Virtual Box v. 4.3.22.

I am getting the following error message:

Virtual Box - Error In VirtualBox

WinVerifyTrust failed on stub executable: WinVerifyTrust failed with hrc=Unknown Status 0x8009200D on '\Device\HarddiskVolume6\Program Files\Oracle\VirtualBox\VirtualBox.exe' (rc=-22919)

Please try reinstalling VirtualBox.

I have attempted to remove the most recent Windows Update issue mentioned in other posts, but there are a myriad of other problems that come up after this.

This is very critical to my business and I have spent hours fruitlessly trying to fix this to no avail. Any help would be greatly appreciated.

[frank]

Please could you attach the VBoxHardening.log file?

[BennerLiu]

I have the same problem, and found that this:
0x8009200DCRYPT_E_BAD_MSGNot a cryptographic message or the cryptographicmessage is not formatted correctly
but still got no luck to a solution.

[BennerLiu]

I have the same problem, here is my log

[CountryLawyer]

I just upgraded to 4.3.34, but in the process of trying to fix the situation, something got royally messed up. I am desperate for any help that can be offered, as I use VirtualBox for my accounting software.

When I try to start my most recent snapshot, I'm getting the following error:

VirtualBox - Error

Failed to open a session for the virtual machine XPMode.

pci#0: Device in slot 0x30 has been removed!
vendor=0x106b device=0x003f [ver=3 pass=final]
(VERR_SSM_LOAD_CONFIG_MISMATCH).

Result Code: E_FAIL (0x80004005)
Component: Console
Interface: IConsole
{8ab7c520-2442-4b66-8d74-4ff1e195d2b6}

If I can figure out how to create a zip file, I can post the log you are requesting. Otherwise, can you provide me an e-mail address to which I could e-mail a text file?

[scottgus1]

Save the hardening log Frank asked for to your desktop. Right-click it and choose "Send To", then "Compressed (zipped) folder". On the forum, Attach the Zip file using the "Upload Attachment" tab below the post text box.

[frank]

I have the same problem, here is my log

Please upgrade to 5.0.10!

[michaln]

pci#0: Device in slot 0x30 has been removed!
vendor=0x106b device=0x003f [ver=3 pass=final]
(VERR_SSM_LOAD_CONFIG_MISMATCH).

Some sort of problem with USB device configuration. Hard to say what exactly. What was the snapshot created with?

[CountryLawyer]

Ok... For good measure, on this and the next post I am just posting zip files of everything in my Windows (C:)/Users/James/VirtualBox VMs/XPMode/Logs folder.

My snapshot was made by just going up to the left corner in VirtualBox and selecting the option to take a snapshot. I'm certain the problem occurred in my attempts to upgrade to 5.0.10, then uninstall, then install lower versions.

[CountryLawyer]

Here are the other 2 files...

[frank]

Install the corresponding Extension Pack. USB is part of the Extension Pack.

[CountryLawyer]

I just installed the Extension Pack and rebooted and still receiving identical error message.

[Perryg]

I just installed the Extension Pack and rebooted and still receiving identical error message.

Post a new log file. Only the one that says .log please since it will be the newest.

[CountryLawyer]

Perryg... Per your request.

[Perryg]

Have you actually rebooted the guest? It looks like you are using saved state and that will be an issue with this kind of thing.

I would also recommend that you keep daily (complete) backups since you are using so many snapshots on a VHD guest.