int09h_handler(): scancode & asciicode are zero?

[Sunny Jim]

Guest OS is Ubuntu 14.04

Ubuntu installation includes an option to boot from CD (in this case, ISO image). When I boot from that media, there is no problem. The installation was also successful.

However, I cannot boot from the virtual disk. The following entries log continuously (in 3-4 minute intervals) until I shut down the VM. The entries below are typical for approximately 40 lines.

Code: Select all

875:18:08:22.266275 Guest Log: BIOS: KBD: int09h_handler(): scancode & asciicode are zero?
876:18:08:23.038379 Guest Log: BIOS: KBD: int09h_handler(): scancode & asciicode are zero?
877:18:08:31.640367 Guest Log: BIOS: KBD: int09h_handler(): scancode & asciicode are zero?
878:18:08:31.827739 Guest Log: BIOS: KBD: int09h_handler(): scancode & asciicode are zero?

[loukingjr]

See Minimum information needed for assistance.

[harink79]

hi, was your problem resolved? I too face the same issue..

[scottgus1]

Harink, Sunny Jim hasn't been back in over a year and this was his only post. If he did solve his problem it's unlikely he will be back to report on it.

Lou's post is what you need to read. Then we can help.