Page 1 of 1

Cannot start VM after upgrading CPU

Posted: 14. Jan 2014, 04:02
by RickNWichita
After upgrading the CPU in my Linux Mint 14 system the following error message occurs when I attempt to open any of my VM's:

Failed to open a session for the virtual machine MS WinXP Home.

cpum#1: "CPU model" mismatch: host=0x17 saved=0xf [ver=14 pass=final] (VERR_SSM_LOAD_CPUID_MISMATCH).

Result Code: NS_ERROR_FAILURE (0x80004005)
Component: Console
Interface: IConsole {db7ab4ca-2a3f-4183-9243-c1208da92392}

Is there a resolution that avoids reinstalling?

Re: Cannot start VM after upgrading CPU

Posted: 14. Jan 2014, 04:10
by Perryg
Was/were the guest/s in saved mode instead of shut down?

Re: Cannot start VM after upgrading CPU

Posted: 14. Jan 2014, 04:29
by RickNWichita
All were saved.

Re: Cannot start VM after upgrading CPU

Posted: 14. Jan 2014, 05:33
by Perryg
Then you will need to discard the saved state before they will work.

Re: Cannot start VM after upgrading CPU

Posted: 14. Jan 2014, 06:15
by RickNWichita
Done! That did the trick, many thanks.

Re: Cannot start VM after upgrading CPU

Posted: 15. Jan 2014, 23:08
by RickNWichita
What is the best way to shut down a VM?

Re: Cannot start VM after upgrading CPU

Posted: 16. Jan 2014, 00:02
by Perryg
You shut the virtual guest down the same way you do on metal.