Page 1 of 1

Can not get DVD/CD Drive to work

Posted: 1. Sep 2013, 06:42
by Impala
I can not get my DVD/CD drive to work in VB. I have installed the extension pack but I get an error message that the CD driver is not found.

the drive spins up when the VM starts. But I can not see the host DVD drive in my VB. I also can NOT run any of the virtual virtual drives that I mount. NONE of them are visible when I try to use them.

Re: Can not get DVD/CD Drive to work

Posted: 1. Sep 2013, 09:14
by mpack
Impala wrote:I get an error message that the CD driver is not found
I assume that's "drive" not "driver". Please give precise error messages. Without that anything I might say would be uninformed speculation.

And why did you think the extension pack was relevant to this? Is it a USB drive?

Re: Can not get DVD/CD Drive to work

Posted: 1. Sep 2013, 09:46
by Impala
The drive is not working.

Exact Error message:
"Found New Hardware Wizard
Cannot Install this Hardware
There was a problem installing this hardware:
VBOX CD-ROM
An error occurred during the installation of the device
The parameter is incorrect
Click Finish to close the wizard"