Page 1 of 1

VRDP on NAT connection - not working

Posted: 14. May 2013, 00:43
by oranev
I have a Windows 7 Host & a Windows XP Guest. I'd like to be able to run it headless & VRDP into it. Guest Additions are installed. It's set up as a NAT connection with the Remote Display Enabled & the port set to 6000. When I attempt to RDP from the host computer using localhost:6000, it does not work. Does anyone know what I might be doing wrong?

Screenshots attached for illustration

EDIT: I can only see the last image. Not too familiar w/the forum. Can anyone see the two before it?

Re: VRDP on NAT connection - not working

Posted: 14. May 2013, 00:52
by Perryg
VRDP is only available if you install the Extension Pack. Have you installed it?
How to install Extension Pack

Re: VRDP on NAT connection - not working

Posted: 14. May 2013, 01:08
by oranev
Perryg wrote:VRDP is only available if you install the Extension Pack. Have you installed it?
How to install Extension Pack
I always forget the extension pack! Thank you

Re: VRDP on NAT connection - not working

Posted: 27. Jun 2013, 09:56
by Alex2342
I have installed extpack, but vrdp does not work.

Re: VRDP on NAT connection - not working

Posted: 28. Jun 2013, 08:31
by noteirak
Please create your own topic with a detailed description of what "is not working". Also, make sure to read Minimum information needed for assistance.