virtualbox.org

Hi. Sorr for my bad english

I have a virtual machine that it is Win2003
and I always I turned off. Then again, when included with the reconvened Snapshots
when I changed my computer, began appearing error:

Failed To Load Unit 'mm'
(VERR_SSM_LOAD_MEMORY_SIZE_MISMATCH)

End of statistics:

00:00:01.252179 ********************* End of statistics **********************
00:00:01.270078 NAT: zone(nm:mbuf_cluster, used:0)
00:00:01.270411 NAT: zone(nm:mbuf_packet, used:0)
00:00:01.270417 NAT: zone(nm:mbuf, used:0)
00:00:01.270466 NAT: zone(nm:mbuf_jumbo_pagesize, used:0)
00:00:01.270768 NAT: zone(nm:mbuf_jumbo_9k, used:0)
00:00:01.270926 NAT: zone(nm:mbuf_jumbo_16k, used:0)
00:00:01.271017 NAT: zone(nm:mbuf_ext_refcnt, used:0)
00:00:01.275975 Changing the VM state from 'DESTROYING' to 'TERMINATED'.
00:00:01.323482 ERROR [COM]: aRC=E_FAIL (0x80004005) aIID={db7ab4ca-2a3f-4183-9243-c1208da92392} aComponent={Console} aText={Failed to load unit 'mm' (VERR_SSM_LOAD_MEMORY_SIZE_MISMATCH)}, preserve=false
00:00:01.323595 Power up failed (vrc=VERR_SSM_LOAD_MEMORY_SIZE_MISMATCH, rc=E_FAIL (0X80004005))

Log is attached
Thanks all.

VBox.log wrote: 00:00:00.595708 Host RAM: 2047MB total, 578MB available
00:00:00.781150 RamSize <integer> = 0x0000000020000000 (536 870 912, 512 MB)
00:00:00.781701 VRamSize <integer> = 0x0000000001000000 (16 777 216, 16 MB)

Not good. This VM is using far too much of the hosts available memory. Although this probably isn't responsible for the reported problem, it will cause instability. You need to free up some host RAM. There's really no reason an XP host should be consuming 1.4GB RAM.

The error is caused by loading a saved state that doesn't match the current VM, e.g. you moved hosts, changed the VM recipe or something like that. As the error message says, the memory size has changed, hence the memory dump in the saved state can't be used. You need to right click the VM and discard the saved state.

I mean I can not run this memory dump?

Saved states are not portable, so if you have changed the environment it was saved for then your choices are to restore the original environment or discard the saved state. You should not lose much data, it would be the equivalent of having a power cut. For good practice you should run a disk check after the VM has started.

virtualbox.org

Failed To Load Unit 'mm'

Failed To Load Unit 'mm'

Re: Failed To Load Unit 'mm'

Re: Failed To Load Unit 'mm'

Re: Failed To Load Unit 'mm'