Page 1 of 1
Seamless mode is deactivated. How to activate it?
Posted: 19. Dec 2011, 13:26
by mjampala
Switch to Seamless mode is deactivated. How to activate it?
Re: Seamless mode is deactivated. How to activate it?
Posted: 19. Dec 2011, 16:08
by mpack
Install the guest additions. AFAIK that is the only requirement.
Re: Seamless mode is deactivated. How to activate it?
Posted: 23. Dec 2011, 12:25
by mjampala
Thank you. I tried that, but installtion is throwing errors like cannot write d3d8.dll and d3d9.dll. Any idea of this errors?
Re: Seamless mode is deactivated. How to activate it?
Posted: 23. Dec 2011, 13:35
by stefan.becker
Have you read the Manual about installing the GA in safe mode?
Re: Seamless mode is deactivated. How to activate it?
Posted: 23. Dec 2011, 14:04
by mpack
If you have 3D acceleration enabled in the VM settings then you must install the GAs in safe mode.