Re: Cannot connect USB devices
Posted: 7. Jan 2011, 22:57
I had a similar problem for my USB scanner.
This is what finally worked (after doing lots of tinkering around)
The key is to modify the USB settings of the VM as follows (also check screenshot below) -
1) In the USB settings, remove the checkmark against the "Enable USB 2.0 (EHCI) Controller" property.
2) Also then add a USB filter to the VM and set the "Remote" property to "Any".
After this scanning will work through the VM. Just make sure that you first start the VM and then connect the printer to the host.
All the best !
/Saurabh
This is what finally worked (after doing lots of tinkering around)
The key is to modify the USB settings of the VM as follows (also check screenshot below) -
1) In the USB settings, remove the checkmark against the "Enable USB 2.0 (EHCI) Controller" property.
2) Also then add a USB filter to the VM and set the "Remote" property to "Any".
After this scanning will work through the VM. Just make sure that you first start the VM and then connect the printer to the host.
All the best !
/Saurabh