Switching a remote VM on headless server from NAT to bridged

Lem · Post by **Lem** » 4. Nov 2007, 10:59

Installed a VM on a remote server using the guide in the manual which sets it up to work over NAT so that you can RDP into the session whilst it's installing. I now need to move this VM to bridged networking (or similar) so that I can install more VMs on this server.

What I don't want to do is end up with a VM I cannot connect to, so what is the best way of going about this?

Lem · Post by **Lem** » 4. Nov 2007, 11:43

Hmm.. may not need to do this as I can get my Thin Clients to connect using different rdp ports, which saves quite a bit of faffing around with the network config of my host.