Hello,
I have installed a new Windows 10 guest. I had issues with the display (it does not like 3d accel) but I got that sorted out. The VM sometimes crashes and reboots automatically and gets stuck in a boot loop until I get the Windows recovery console where I shut it down.
Any ideas what might be wrong?
This is on a Dell Latitude 5420 laptop.
Log attached.
Thank you.
Windows 10 guest boot loop
Windows 10 guest boot loop
- Attachments
-
- Windows10-2022-06-10-15-58-41.zip
- (35.92 KiB) Downloaded 5 times
Re: Windows 10 guest boot loop
My apologies, I posted in the wrong section. This should be moved to Windows Guests.
-
scottgus1
- Site Moderator
- Posts: 20945
- Joined: 30. Dec 2009, 20:14
- Primary OS: MS Windows 10
- VBox Version: VirtualBox+Oracle ExtPack
- Guest OSses: Windows, Linux
Re: Windows 10 guest boot loop
So far this actually appears to be a host issue, so good choice on the subforum! 
Hyper-V is enabled and the massive time offset is present. So it's likely that you're up against the recent Windows 10/11/Hyper-V attempt bug.
The VM could use a second processor, which might clear up the problem. (Even if it doesn't, Windows 10 adores two processors.)
You could try turning off Hyper-V, see HMR3Init: Attempting fall back to NEM (Hyper-V is active).
Or try the 6.1.35 test build. If you go this route, save the test build installer until you update again later.
Hyper-V is enabled and the massive time offset is present. So it's likely that you're up against the recent Windows 10/11/Hyper-V attempt bug.
The VM could use a second processor, which might clear up the problem. (Even if it doesn't, Windows 10 adores two processors.)
You could try turning off Hyper-V, see HMR3Init: Attempting fall back to NEM (Hyper-V is active).
Or try the 6.1.35 test build. If you go this route, save the test build installer until you update again later.