Below is the original post.Setup Detection Error
Error SU-0013
Setup could not create files on your startup drive
and cannot set up Windows.
If you have HPFS or Windows NT file system, you
must create an MS-DOS boot partition. If you have
LANtastic server or SuperStor compression, disable it
before running Setup. See SETUP.TXT on Setup Disk
1 or the Windows CD-ROM.
I have the boot disk image (IMG) and the install CD-ROM (ISO). I mounted both on my 2 GB VM and booted the IMG. It ran fine, and after going through most of the alphabet I finally found out that the CD ended up at R:\ for whatever reason. Then I tried to install Windows 95, and ran into this (keystrokes are denoted in square brackets):
Code: Select all
R:\>SETUP.EXE
Please wait while setup initializes.
Setup is now going to perform a routine check on your system.
To continue, press ENTER. To quit Setup, press ESC. [ENTER]
This version of Microsoft's ScanDisk will work only with MS-DOS versions 5.0 and
later.
Setup found a compressed volume or a disk-cache utility on your
computer. Quit Setup and check your compressed volume with
your disk compression software or remove the disk-cache utility.
Then run Setup again.
If you have already done so, press ESC.
For more information, see SETUP.TXT on Setup Disk 1 or the Windows CD.
To quit Setup, press ENTER. To continue with Setup, press ESC. [ESC]
Please wait while Setup initializes.
Cannot create a temporary directory.
If you have HPFS or NTFS installed on your hard drive,
you will need to create an MS-DOS boot partition to set up Windows.