Fehler ID: NoDNSforNAT
Posted: 16. Jun 2007, 17:53
VirtualBox shows a box when starting my VM:
Fehler ID: NoDNSforNAT
A Domain Name Server (DNS) for NAT networking could not be determined. Ensure that your host is correctly connected to an ISP. If you ignore this warning the guest will not be able to perform nameserver lookups and it will probably observe delays if trying so.
Fehler ID:
NoDNSforNAT
Dringlichkeit:
Warnung
Behind the Box Debian starts fine, but no Nameserver available.
Do I really have to start a DNS for NAT networking and how?
ifconfig:
en0: flags=8863<UP,BROADCAST,SMART,RUNNING,SIMPLEX,MULTICAST> mtu 1500
inet6 xxxx::xxx:xxxx:xxxx:xxx%en0 prefixlen 64 scopeid 0x4
inet xxx.xxx.xxx.xxx netmask 0xffffff00 broadcast xxx.xxx.xxx.255
ether xx:xx:xx:xx:xx:xx
media: autoselect (100baseTX <half-duplex>) status: active
supported media: autoselect 10baseT/UTP <half-duplex> 10baseT/UTP <full-duplex> 100baseTX <half-duplex> 100baseTX <full-duplex>
Fehler ID: NoDNSforNAT
A Domain Name Server (DNS) for NAT networking could not be determined. Ensure that your host is correctly connected to an ISP. If you ignore this warning the guest will not be able to perform nameserver lookups and it will probably observe delays if trying so.
Fehler ID:
NoDNSforNAT
Dringlichkeit:
Warnung
Behind the Box Debian starts fine, but no Nameserver available.
Do I really have to start a DNS for NAT networking and how?
ifconfig:
en0: flags=8863<UP,BROADCAST,SMART,RUNNING,SIMPLEX,MULTICAST> mtu 1500
inet6 xxxx::xxx:xxxx:xxxx:xxx%en0 prefixlen 64 scopeid 0x4
inet xxx.xxx.xxx.xxx netmask 0xffffff00 broadcast xxx.xxx.xxx.255
ether xx:xx:xx:xx:xx:xx
media: autoselect (100baseTX <half-duplex>) status: active
supported media: autoselect 10baseT/UTP <half-duplex> 10baseT/UTP <full-duplex> 100baseTX <half-duplex> 100baseTX <full-duplex>