Hello,
I just recognized the language.
I'm using Kununtu 8.04 and want to work in Virtualbox under XP with the CAD programm Catia. No problem so far, but now I want to use my 3Dconnexion Space Navigator (a spaceball). It runs under Linux, I can also install the driver in XP, but the space ball is not working. I got no Error message during installation.
Is it possible to get a device like this (a special mouse on USB port) running?
Eric
Spaceball 3Dconnexion under Virtualbox
Spaceball 3Dconnexion under Virtualbox
Last edited by MacMoto on 11. Feb 2009, 15:28, edited 2 times in total.
Re: Spaceball 3Dconnexion under Virtualbox
Same Problem:
Host: Debian Jessie (64bit) on AMD 64 machine.
Guest: Windows 7 Pro (64bit) on Virtual Box
Creo 3.0 is running fine at the Guest.
I want to use my 3dconnexion space pilot pro.
I don't need the space pilot at the host system.
The installation of the driver at the guest system executed without errors.
But the space pilot isn't working correctly, only the mouse pointer is running along the screen (very fast), if I operate the space pilot.
I think, the best solution would be, to route the usb connection of the space pilot directly to the guest system,
but how can I do?
Does anyone know?
Best regards,
Kaengo
Host: Debian Jessie (64bit) on AMD 64 machine.
Guest: Windows 7 Pro (64bit) on Virtual Box
Creo 3.0 is running fine at the Guest.
I want to use my 3dconnexion space pilot pro.
I don't need the space pilot at the host system.
The installation of the driver at the guest system executed without errors.
But the space pilot isn't working correctly, only the mouse pointer is running along the screen (very fast), if I operate the space pilot.
I think, the best solution would be, to route the usb connection of the space pilot directly to the guest system,
but how can I do?
Does anyone know?
Best regards,
Kaengo