Page 1 of 1
No start of Antergos after Update
Posted: 25. Feb 2019, 16:59
by an0n1mous
Hello,
Antergos won't run after a Update. I don't know, if it is the Antergos-Update or the VBox-Update or both...
But I can give you the report, VBox give me out, when I start unsuccessfull Antergos on my Antergos-Host.
One last tip. When I start an older protection point, a protection point from 22.02.2019, then Antergos start perfekt. The problem appears in that case after die date.
I hope you could help, because so I could not import any Update of Antergos and/or VBox and the system is UNSAFE! In my eyes, this is a big catastrophe.
This problem is also here posted:
https://forum.antergos.com/topic/11432/ ... ter-update
Re: No start of Antergos after Update
Posted: 25. Feb 2019, 17:20
by mpack
The error message highlighted is caused by upgrading VirtualBox while the VM was in a suspended state. Right click the VM in the manager and discard the saved state: the VM will behave like a physical PC after a power cut.
Re: No start of Antergos after Update
Posted: 25. Feb 2019, 17:26
by an0n1mous
@ mpack: Sorry, but so clever I also was.
When I delete the protection point which makes problems, then I take the working protection point vom 22.02.2019, then I make Updates and a reboot, then safing the new state of the maschine, then I close the maschine, then I start the new protection point and the problem is the same.
ONLY the old protection point works, but I am not allowed to update the old working state, because then the problem appears.
Re: No start of Antergos after Update
Posted: 25. Feb 2019, 17:32
by mpack
It isn't clear to me what you are saying. The error is with a saved state file trying to restore a state that is incompatible with the upgraded version of VirtualBox. If the saved state is discarded then the error cannot occur.
Re: No start of Antergos after Update
Posted: 25. Feb 2019, 17:48
by an0n1mous
Update:
1. I take the working protection point (the machine did not boot, the working protection point is a running (!) machine) and start all updates
2. I reboot the machine
3. I save the new state of the machine with the updates
The rest would be important:
4. I turn off the machine completely (so that the machine have to boot after starting)
5. The machine boot
6. Now Antergos ist running, without problems -> I make a new protection point of the RUNNING machine
7. I close the machine
8. I start the machine without problems
WORKAROUND
Re: No start of Antergos after Update
Posted: 25. Feb 2019, 18:08
by socratis
Take a look at the Known Issues in the "
Discuss the 6.0.0 release" post.
You are seeing the effects of saved states not being restored in 6.0.x. There are three of them (and many, many duplicates):