Whenever I ran ifconfig or ifconfig -a only the lo interface was present and no eth0 was displayed. I also looked in the /etc/sysconfig/network-scripts/ for the ifcfg-eth0 file, but the file was not present.
I tried creating the file and rebooting but the vm still lacked any sort of network access. I created the ifcfg-eth0 file by using the following:
Code: Select all
DEVICE="eth0"
HWADDR=08:00:27:8B:72:61
NM_CONTROLLED="no"
ONBOOT="yes"
BOOTPROTO="dhcp"
I obtained the MAC Address by going to Settings -> Network -> Advanced -> Mac Address.
Ideally I want to get NAT Network working but right now I can't get any of the virtual networking modes to work.
VirtualBox Version: 5.2.8 r121009 (Qt5.6.2)
Host: Windows 10 x64 4GB RAM
Guest: Red Hat 6.2 i686 1024 MB RAM (No Guest Additions Installed)