USB 3.0 flash drive captures inconsistently, runs at slow speeds when captured
Posted: 6. Jun 2018, 19:36
I am running Mac OS High Sierra 10.13.2 with four Thunderbolt 3 ports; my VirtualBox is running using Windows 7, 64-bit Home Premium; VB version 5.2.12 r122591 (Qt5.63), 5.2.12 Guest Additions Packet, USB 3.0 Extensible Host Drivers loaded.
I've spent the last three days trying to get my USB Flashdrive (SanDisk Ultra USB 3.0) to capture in the Windows environment. It captured yesterday, but the drive was running so slow most of the files wouldn't load. Eventually, the connection would degrade. Tried a new flash drive this morning. The USB flash drive captured, I was able to navigate through files and load two JPEGs, but then the connection eventually slowed.
Watched a tutorial to check USB speed/compatibility and to perhaps change a setting in the Windows environment. (That's another rabbit hole). Realized, I think, that you can't run BIOS to check the USB setting, but Windows froze when I hit the delete key (still thinking then I could run BIOS) when loading and eventually had to run repairs, which it did successfully. Now, I am unable to get the USB drive to capture again.
Log is attached. Did my best to follow directions after going through steps 1-8 in USB 3.0 forum.
Thank you!
I've spent the last three days trying to get my USB Flashdrive (SanDisk Ultra USB 3.0) to capture in the Windows environment. It captured yesterday, but the drive was running so slow most of the files wouldn't load. Eventually, the connection would degrade. Tried a new flash drive this morning. The USB flash drive captured, I was able to navigate through files and load two JPEGs, but then the connection eventually slowed.
Watched a tutorial to check USB speed/compatibility and to perhaps change a setting in the Windows environment. (That's another rabbit hole). Realized, I think, that you can't run BIOS to check the USB setting, but Windows froze when I hit the delete key (still thinking then I could run BIOS) when loading and eventually had to run repairs, which it did successfully. Now, I am unable to get the USB drive to capture again.
Log is attached. Did my best to follow directions after going through steps 1-8 in USB 3.0 forum.
Thank you!