LM19.3 MATE
VB 6.0.4
Old PC
LM17.3 KDE
VB 5.1.14
Guest Machine WinXP
Attempt 1
Copying of complete folder from the old PC to an USB stick gives always the error and the copying process stops.
rost=my PC nameCould not write file/media/rost/8GBFat32_01/WFM Basic_01/WFM Basic-disk1.vmdk
8GBRFat32_01 = USBstick name, (GB, VM total files size is <7GB)
WFM Basic_01 is the name of the VM
Attempt 2
I exported the same VM into a folder at the old PC.
Copied it over to a USB stick
Copied it over to my new PC
Clicked Import and selected the exported machine
Used Mac Address Policy as default (Include only NAT network adapter MAC addressess
Addtional Options: Checked and Import hard drives as VDI
VM import works; no error messages or warnings
When I start the VM, I get the error message:
Opened "Change Network Settings"Could not start the machine WFM Basic_01 because the following physical network interfaces were not found:
eth0 (adapter 1), eth0 (adapter 2)
You can either change the machine's network settings or stop the machine.
Adapter 1 and Adapter 2
Bridged Adapter
Name: enp0s25
As the roll-down menu shows 1 alternativ, I set both adapters to: wlp3s0
However, this seems not to be the solution because the OK button is still greyed out.
Thus I can only choose Cancel
Then I get the error message:
After clicking OK, the start up process of the VM stops.Failed to open a session for the virtual machine WFM Basic_01.
Nonexistent host networking interface, name 'eth0' (VERR_INTERNAL_ERROR).
Result Code: NS_ERROR_FAILURE (0x80004005)
Component: ConsoleWrap
Interface: IConsole {872da645-4a9b-1727-bee2-5585105b9eed}
I appreciate a lot your help.