I was trying to setup and run a Windows 98 Guest in a Windows 7 Host, and i was following the extremely helpful tutorial (Windows 98SE step by step) made by Kurt_Aust.
During one of the steps to properly install the win98, which was to install SciTech's Display Doctor and then configure it, I ran into a problem after these specific steps:
[...]
- Choose Monitor Model - (Standard monitor types) - Super VGA 1600x1200
- Click Display Driver then change Active Driver to SciTech Nucleus Driver and reboot
The system starts normally if I run it with Safe Mode, but will run into the same problem if I restart it again (and choosing Normal Mode).
I've already restored a snapshot and reinstalled SciTech's Display Doctor, but the same error will happen. Just in case, here's my host computer specs:
Windows 7 Home Premium 64x Bit;
AMD Athlon(tm) II P340 Dual-Core Processor 2.20 GHz;
2.00 GB RAM;
VirtualBox VM 4.3.40 r110317 win.amd64;
AMD-V enabled in the BIOS.
I've also attached the BOOTLOG.txt file that the Win98 guest can generate during startup. I'm sincerely clueless on what to do.
If you made it this far, Thank you for your attention!
(sorry for any spelling mistakes)
(If this is at the wrong topic section, please tell me so I can change it)