I've turned on both a NAT and host only network adaptor in the guest, but can't access other machines on the network. This does work with a Linux guest running on the same host. Oddly, the two network adaptors are given IP addresses on the same subnet. Ping works to 192.168.56.1 on the guest, but doesn't on the host to either Win10 guest IP address. Ping on the host works to the 192.168.56.x address of the Linux guest.
Shouldn't this be straightforward and "just work"?
Code: Select all
$ ipconfig
Windows IP Configuration
Ethernet adapter Ethernet:
Connection-specific DNS Suffix . :
Link-local IPv6 Address . . . . . : fe80::cd49:8fdd:78f8:865d%13
IPv4 Address. . . . . . . . . . . : 192.168.56.100
Subnet Mask . . . . . . . . . . . : 255.255.255.0
Default Gateway . . . . . . . . . : 192.168.56.1
Ethernet adapter Ethernet 2:
Connection-specific DNS Suffix . :
Link-local IPv6 Address . . . . . : fe80::6831:a6fc:fe3d:726a%7
IPv4 Address. . . . . . . . . . . : 192.168.56.101
Subnet Mask . . . . . . . . . . . : 255.255.255.0
Default Gateway . . . . . . . . . :
Code: Select all
IPv4 Route Table
===========================================================================
Active Routes:
Network Destination Netmask Gateway Interface Metric
0.0.0.0 0.0.0.0 192.168.56.1 192.168.56.100 281
127.0.0.0 255.0.0.0 On-link 127.0.0.1 331
127.0.0.1 255.255.255.255 On-link 127.0.0.1 331
127.255.255.255 255.255.255.255 On-link 127.0.0.1 331
192.168.56.0 255.255.255.0 On-link 192.168.56.100 281
192.168.56.0 255.255.255.0 On-link 192.168.56.101 281
192.168.56.100 255.255.255.255 On-link 192.168.56.100 281
192.168.56.101 255.255.255.255 On-link 192.168.56.101 281
192.168.56.255 255.255.255.255 On-link 192.168.56.100 281
192.168.56.255 255.255.255.255 On-link 192.168.56.101 281
224.0.0.0 240.0.0.0 On-link 127.0.0.1 331
224.0.0.0 240.0.0.0 On-link 192.168.56.100 281
224.0.0.0 240.0.0.0 On-link 192.168.56.101 281
255.255.255.255 255.255.255.255 On-link 127.0.0.1 331
255.255.255.255 255.255.255.255 On-link 192.168.56.100 281
255.255.255.255 255.255.255.255 On-link 192.168.56.101 281
===========================================================================
Persistent Routes:
Network Address Netmask Gateway Address Metric
0.0.0.0 0.0.0.0 192.168.56.1 Default
===========================================================================
Code: Select all
192.168.56.0 255.255.255.0 On-link 192.168.56.1 266
Code: Select all
glenn.burkhardt@ms110dev:~$ ifconfig
enp0s3 Link encap:Ethernet HWaddr 08:00:27:ca:14:08
inet addr:10.0.2.15 Bcast:10.0.2.255 Mask:255.255.255.0
inet6 addr: fe80::bc0a:568b:31c3:8d96/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:19 errors:0 dropped:0 overruns:0 frame:0
TX packets:27 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:2984 (2.9 KB) TX bytes:2712 (2.7 KB)
enp0s8 Link encap:Ethernet HWaddr 08:00:27:e4:56:3c
inet addr:192.168.56.102 Bcast:192.168.56.255 Mask:255.255.255.0
inet6 addr: fe80::18ea:c58a:b5c3:81ab/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3 errors:0 dropped:0 overruns:0 frame:0
TX packets:10 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1262 (1.2 KB) TX bytes:1308 (1.3 KB)